UniSteer 8010780-01 Rack and Pinion

Rack and Pinion - Power - 1964-67 GM A-Body - 396-454 - Short Water Pump

• This kit was specifically designed to fit Chevy A-Body cars. This is a front steer center take off style rack And pinion mounted on a one piece bracket that bolts in the same mounting holes used for the factory steering box and idler arm.
• The rack matches the stock suspension on these cars replicating the original center link. The kit clears the Z-Bar and 4 Speed Linkage.
• The kit has been used on both Small Block and Big Block motor cars. Stock Manifolds work with both motors and on Big Blocks
• we have used Super Comp Headers while on Small Block Motors
• Hooker Competition Headers have been used.
• Other headers may work
• but may need modification. Shaft kits are included in both small block and big block kits
• and require using 3 u-joints and support bearing.
• Pump kits are also included; the big block motor pump kit uses a matched pump
• single V-groove pulley
• bracket
• and remote reservoir.
• The small block
• motor pump kit includes a matched pump
• single V-groove pulley
• bracket
• and clip-on reservoir.
• Note: Most aftermarket Heads have raised exhaust floors by 1/4"" to 1/2"" which does not make clearance any easier.
• Note: This kit will also bolt into a 1964-67 Big block El Camino.
• Big block motor cars: The original Mark IV design has a deck height of 9.8""
• the Mark V and Mark VI designs have a deck height of 10.2"". The 0.4"" difference affects clearance on these big block cars.
• Big block motor cars: Mark V and Mark VI designed cars will probably need header modification.

Class up your Chevelle/El Camino steering with this bolt in Rack And Pinion Kit to greatly improve your handling, your steering, and your life in the fast lane...ok maybe not that far.