UniSteer 8001550 Rack and Pinion

Rack and Pinion - Manual - without Column - 1958-62 Corvette

• This kit that starts with a rear steer center take off style rack & pinion made to match the stock suspension of these Corvettes.
• The rack is mounted to a one piece bracket that mounts to the stock motor mounts. The kit does clear the z-bar and 4 speed linkage.
• This kit works on Small Block motor cars with stock manifolds or Shorty headers. Other headers may work with modification.
• Everything that you need is included minus the Ididit column. The shaft kits use three u-joints and a support bearing.
• This connects up with a new Ididit retrofit column. You must use the column to use this kit! Floor Bracket and Gasket are included.
• Note: An Ididit retrofit Column is needed for this kit to work. Unisteer does not Provide Ididit Column.

Time your classic Vette gets a makeover with Unisteer’s bolt in kit! Precise rack & pinion steering in your classic Vette!