UMI 2236-R 82-02 F-Body Torque Arm Crossmember, Weld In, Red

UMI's 2236 weld-in torque arm is a great way to get UMI quality and performance in your 3rd and 4th Gen F-Body. The shortened torque arm length improves instant center and provides reduced 60 ft times and enhanced forward traction. The adjustment feature allows for optimizing the pinion angle and ensures a vibration-free driveline at any ride height. The #2236 unit is designed with a straight front cross member to clear tight fitting header/y-pipe set-ups. Since crossmember installation is weld in you have the ability to raise or lower crossmember before welding for perfect clearance. Installation note: Crossmember installation requires welding and cutting to complete installation. Torque arm must be installed with 2-point subframe connectors.

Torque Arm Benefits:

• Removes torque arm from transmission tail shaft to prevent damage

• Eliminates wheel hop on launch and solves forward traction problems

• Allows for on-car pinion angle adjustments

• Polyurethane bushings designed to keep road noise at a minimum

• Front mounting point utilizes a greaseable pivot point

Features:

• Torque arm constructed of 1.250” x 0.120” DOM steel tubing

• Crossmember constructed of 1.500” x 0.120” DOM steel tubing

• TIG Welded 4140 Chromoly tube adapters

• On-Car adjuster built using 4140 Chromoly steel & heat treated for maximum strength

• Polyurethane bushings are greaseable to prolong bushing life

• Laser cut plates ensure hole to hole accuracy

• Rear mounting plates use 0.375” thick mild steel

• Fits stock rear end as well as 12-Bolt, 9” & S60 Rear-End Housings.

• Brilliant Durable Red or Black powder coat

Chromoly: Chromoly version uses 1.250" x 0.095" 4130 Chromoly steel and features 100% TIG welded construction. This adds increased strength and reduces product weight, recommended for vehicles running 10.50’s and faster in the ¼ mile.

Rear Torque Arm Hardware Kit: Through bolt rear axle housings require UMI P/N 3003 to complete installation on factory housings, Strange, Moser 9” and most other housings. UMI P/N 2998 should be used on Moser 12-bolt with the four bolt mount design.

Installation Instructions (PDF)