Taylor 70251 8mm Spark Plug Wires, 90 Degree, Red, Resistor Core

Great wires (one complaint)

Exactly what you'd expect for a good quality set of spark plug wires. The only gripe I have with these is the fact that when I went to take some off a bank of plugs on my sbc, the metal contact ripped out of every single plug wire boot and just stayed on the plug. I did a correct install and everything. Even used dielectric grease on both ends. They were less than a year old, too. I was trying to be as careful as possible, but it's a little disappointing when 95 bucks go down the drain.

Excellent product I would purchase again

Excellent product good quality everything worked well except kit was missing coil wire terminals and boots

awesome wires love them

would buy from here again!

Good wires

These are nice wires. The only problem I have with the set are the boots. They don't fit tight on the coil or on the distributor cap. They are very soft and do not grip well. They do fit OK but I will have to check them occasionally to make sure the boots are snug.

Great plug wires, heavy duty, look awesome

Bought these spark plug wires for my 1966 Buick Skylark Gran Sport with the factory distributor cap and 50000 volt breakerless ignition system installed under the factory cap. They have low ohm resistance, have a very very durable 90 degree end for the spark plug, and easy installation with the crimper tool (not included) Dielectric grease is included for ease of sliding the boot over the silicone.

They look very good

Have not had a chance to install them yet. Going to install them on a 1952 mercury flathead engine with a new Mallory distributor and coil .

Idont know if i would buy that product anymore.

The wires are a fit and good looking but the problem is the wires are still sparking .

Sharp

Thought the HEI boots were going to be red to match the set, there are black, bummer

Another good buy

Taylor makes a great product. I used these on my HEI distributor. The HEI ends are made so they do not require the plug wire to be bend in the boot. Wire length is extra long which is great when you have to place the wires around headers.

Taylor wire products have always been on

As always, my shopping experience with you folks has been more than satisfactory. The people on the phone are helpful and extremely polite. I'm beginning to think of Nebraska as different world. In so Calif no-one is polite. They may have moved closer to you and left all the rude folks here. Keep up the great job and I'll continue to brag about you and buy all my major parts from your company. Why not open a branch out here? all of our locals are out of business or trying to get rich off each customer.