Sweet Mfg U-Joint, 1 In DD, 3/4 Round, IDIDIT/Flaming River Column
Universal Fit, Single Joint Universal Joint Style, 1" DD Aftermarket End #1, 3/4" Round End #2
- Features forged vanadium steel yokes and u-joint
- Measures 1.354" not including the screws (1.534" including)
- Both ends have a 3/4" DD and has max operating angle of 30 °
- Has a 1.125" OD on the ends not including the nut (1.345" including the nut)
- These steering universal joints feature a double D end to make use of the double D shaft
Dont jeopardize your safety with inferior quality steering components. Speedway offers only the finest steering U-joints available. Made by Sweet Manufacturing. These steering universal joints have a 3/4" round weld-on end.
- Full compliment bearings
- Forged Vanadium steel yokes and u-joint
- Highest quality for racing or street
- Features needle bearing u-joints
Note: GM columns measure slightly less than 1" while IDIDIT and Flaming River columns measure a true 1". DO NOT interchange these u-joints.
Item DetailsGM columns measure slightly less than 1" while Ididit and Flaming River columns measure a true 1".
ApplicationWhen purchasing U-Joints, 3 easy steps will help ensure that they will be correct for your application.
Be sure to measure the diameter of the shaft and count the number of splines on the shaft. Some shafts have a blank spot ground on one side. To get the correct number of splines, use a flat edge and cover the blank half of the shaft through the diameter and count the splines on the other half. Multiply that number by 2, thus giving you the total number of splines on the full circumference of the shaft.
Choose which shaft type best suits your application: 3/4" weld on, 3/4" DD or 1" DD.
With these two pieces of information at hand, refer to our chart to find the appropriate part number of the ujoint for your specific application.
Tech Tip #1: When using more than two universal joints in a system, a support heim must be used.
Tech Tip #2: Increasing a U-Joint's angle of operation beyond 30° dramatically increases the stress on the joint, weakening the whole steering mechanism. If a greater angle is needed, add another u-joint.
The 1” double D end fits the bottom of most of the Ididit steering columns. The opposite end of the u-joint fits a piece of ¾” diameter round shaft. The end going to the ¾” round shaft is typically welded to the shaft or cross-drilled and pinned with a couple of roll pins.
- Get FREE shipping when your order includes this item and exceeds $99! Ground shipping only in the contiguous US.
Q & A
Learn how to hook up a horn button in your vehicle. Watch our video on the install of an Ididit car horn button and our video on turn signal synchronization.
How to install an electronic power steering unit in a micro sprint and the benefits of using power steering. This article includes which parts to use to complete your power steering installation.
Learn how to determine steering box, rack, and spline sizes.
When it comes to a traditional style build on an early hot rod it just has to be rolling on a solid front axle of some sort. In this buyer's guide we take you through I-beam and round tube solid axles, spindle choices, radius rod needs, and more.
Designing a steering system for your street rod or muscle car can be tricky. In this buyer's guide we'll show you how to choose the right steering U-joints, steering shaft, and accessories to complete the job quickly and safely.
If you are confused as to how that new steering wheel you want is going to attach to your project's steering column then this buyer's guide should be your first visit before adding that new wheel to your shopping list.
Jared demonstrates how to install a Sweet Manufacturing collapsible steering column in his 3rd gen Camaro. The collapsible portion not only makes the column safer in a crash but also gives you the length adjustment.