Speedway Forged 4-Bar Rod End, 3/4-16 LH Thread, Zinc Plated

Yes

I purchased two of these to complete the rear portion of the lower rear trailing arms that I fabricated to replace the old arms on my 27 Model T.

I would buy again

I replaced the Heim joint on the end of a pair of adjustable strut rods on a 65 Mustang restromod.

Yes I will buy again

Excellent product Excellent quality Speedway Motors you sell the best parts.

Yes I would buy again

Excellent product Excellent quality Speedway Motors you sell the best parts.

Definitely would buy again

Worked great

good product even thou no grease fittings in them

will use these rod end for my upper torque bars from rear to frame,

Was exactly what I was looking for...

I was looking for a forged bushing end to replace a customer's existing heim joint setup on their four links. Typically we run heims because most of builds are for racing, but on this hot rod build, the customer wanted a little more give and didn't want to deal with the creaking that heims start to produce when they are dry. We needed something a little stronger than the typical bushing with a weld-on threaded shank to handle to power, so these forged ends worked great. They're slightly smaller than most too, so they fit in the link brackets that were already set up to run a heim with misalignment spacers.

Worked perfect and quite than heim joint

For my model t electric conversion

Great price for forged rod ends.

used for trailing arms on Alger sports car.

this is spot on for builds

heavy duty for upper links