Plumb your Small Block Ford fuel system with these complete fuel pump installation kits!
Kit Includes:
- (1) Small Block Ford V8 Mechanical Fuel Pump, 80 GPH, Black
- (1) Fuel Log, 4150 Style Carb, AN -6, Stainless Braid, Black Fitting
- (2) Black 90 Degree -6 AN Flare to 1/4 Inch NPT Pipe Adapter Fitting
- (2) Speedway Full Flow Swivel Hose End Fitting, Straight, Anodized, -6 AN
- (1) Speedway Full Flow Swivel Hose End Fitting, 90 Degree, Anodized, -6 AN
- (1) Speedway Stainless Steel Braided Hose Line, -6 AN, 6 Ft.
Small Block Ford V8 Mechanical Fuel Pump, 80 GPH, Black
- High-performance two-valve mechanical fuel pumps
- Constructed of heavy duty materials for consistent performance and reliability
- Their lower body has been designed to rotate to meet your fitment requirements
- Their aluminum housing is given a stylish black finish
- 80 gph
- 6 PSI
- Aluminum construction
- Fits Small Block Ford applications
Fuel Log, 4150 Style Carb, AN -6, Stainless Braid, Black Fitting
- Fully assembled and ready for installation our Dual Inlet Kits are ready to get you going
- Using stainless steel braided hose each kit comes with newly designed adapter fittings made for faster installation
- With these new adapters the wrench goes on once and you turn until the adapter is locked in
- Each kit comes with a 1/8" port for optional gauge installation, gauges sold separately
- Includes Crush Washers
- -6 AN Fittings
- Fits Holley Dual Feed 4150 (Except 4010)
- Black Anodized
Black 90 Degree -6 AN Flare to 1/4 Inch NPT Pipe Adapter Fitting
- Aluminum pipe thread to 37° AN adapter fitting
- Black anodized finish will give your engine compartment the look you are after
Full Flow Swivel Hose End Fitting, Straight, Anodized, -6 AN
- These compression-style fittings are easier to assemble and offer significantly better seal integrity than out-dated cutter-style fittings
- Manufactured from the highest quality aluminum and are then black anodized to give them a new sleek look
- These full flow hose ends use a swivel head design, allowing the fitting to rotate as you are tightening or assembling the hose
- These fittings come in a straight design
- -6 AN female to push-on style adapter
- Lightweight aluminum hose ends are completely reusable, and interchangeable
- 37° angled sealing surface guarantees a positive anti-leak seal
- Works great for custom fuel lines
- Available in a Black corrosion resistant finish
Full Flow Swivel Hose End Fitting, 90 Degree, Anodized, -6 AN
- -6 AN female to push-on style adapter
- 90 degree angle
- Lightweight aluminum hose ends are completely reusable, and interchangeable
- 37° angled sealing surface guarantees a positive anti-leak seal
- Accepts a variety of lightweight aluminum AN style adapters & fittings
- Works great with custom fuel lines
- Available in a Black corrosion resistant finish
Stainless Steel Braided Hose Line, -6 AN, 6 Ft.
- This stainless steel braided hose can be used for low pressure applications like fuel, water, air or oil
- Works great as a fuel line for non ethanol blended gas
Note: This hose is >>NOT<< compatible with ETHANOL blended GAS including E85 ! ! !
Note: Not to be used for brake or power steering applications. Maximum operating pressure is 750 psi.