Small Block Chevy Crank Mandrel Drive Kit

Yes

Simplest installation

Would buy again

This gives you the ultimate flexibility for pulley size and spacing, whatever water pump you use or any other accessory for that mater. I needed a very small pulley for my vacuum pump and this did the trick.

Works for a Variety of Front Drive Applications

Can be adapted to many 1" front drive mandrel applications.

Yes I would definitely buy this again

It worked out great. I just had to sand the paint off lightly where it goes into the balancer. Other than that it worked out just great

All the pieces worked great together for my crank pully and

Bolts up and fits properly. Spins true on the crank.

Water pump drive kit

Always Great Service Fast Shipping

I would buy this product again

Hooked pulley to run a vaccum pump on a drag car cut it to length I needed and worked great recommend to anyonr

Works as it should

Used with sbc and procharger

Poor Machining Tolerances

Neither the woodruff key or the key stock that was provided with the mandrel fit into the machined keyways. Also, the od on the mandrel that fits into your balancer/pulley bore was too large. I spent about an hour sanding down the key's and mandrel before I could install it.

saves over buying individually

Though I can't comment about it's intended use as I modified it for another engine, it's a collection of quality parts that are needed for driving a pump. Quick shipping and typical excellent speedway service is icing on the cake.