|
#6051675L
$129.00
/each
Factory Shipped
Quantity
Need Help? Call to Order
Add to a list
Select a vehicle to verify Fitment
Select Vehicle
Many Manual Transmissions, 10.500" Diameter
Need help?
855.313.9176Quick and Easy Returns
Return PolicyRam clutches for stock clutch rule classes give you unmatched performance and durability. These 10.5 inch diameter assemblies utilize a nodular iron pressure ring which provides a durable mating surface for the clutch disc. A 2400 lb. pressure spring provides increased static pressure over stock clutches.
If your rules require a full facing or sprung hub disc, the RAM 300 Series organic racing disc provides the best holding power of any organic disc available and adds only about 2 pounds to the total weight of the set.
All Ram street stock clutches are completely rebuildable by the factory.
Tech Tip: When installing a new clutch, be sure to follow the manufacturers instructions for correct set-up. You should also replace the pilot bushing/bearing.
Tech Tip: To extend the life of your expensive racing clutch you should not use it to load the car on or in your trailer. The amount of slippage this causes is worse than a night of racing.
Stock - 17.00 lbs.
Clutches, Flywheels and release bearings are STRICTLY FACTORY WARRANTY ONLY. Customer must return the unit to RAM for evaluation and inspection.
For a full list of warranty information please see our warranty information here
| KEY SPECS | |
|---|---|
| MFG. Part # | 1675L |
| Brand | Ram Clutches |
| Diameter | 10.500" |
| Weight | 17.0 lbs. |
| GENERAL | |
| Sold in Quantity | Each |
| GTIN Code | 809009375955 |
1
1 Review
1
1 reviews
5
0
4
0
3
0
2
0
1
1
Filter by Ratings
Will deffinately not buy again.
1.0
9 years ago
Bryan
St. Louis, mo.
Verified
First off the pedal feel was super soft, which at first was nice, i figured it would make driving with a sintered iron clutch a little easier. But i guess it just doesn't have enough actual clamping force, cause the first time I drove it around all it wanted to do when getting on the throttle it wanted to spin the clutch disc. I don't know if the one I have is defective or what, but it just doesn't seem right.
Would Not Recommend
Showing 1 of 1 reviews
2 Questions • 2 Answers
Will this pressure plate fit a GM LS Flywheel
by BradleyW
• 4 years ago
1 answer
View Answer
What is the input spline count and input shaft diameter?
by Nathan
• 9 years ago
1 answer
View Answer
2 of 2 questions shown
