UniSteer 8050050 1955-1957 Chevy Steering Shaft Kit, Stock

This kit is for use with Unisteer Tri-5 Rack & Pinion kit being installed on small block cars that have header clearance. With header clearance, this is the easiest way to connect the rack & pinion up to the column.

The kit consists of two U-Joints, one already welded to long section of smooth shaft, all one need do is mock up their steering linkage and cut off the shaft at correct length. Then drill and pin the second U-joint to the shaft with the provided hardware, or weld if you prefer.

• 3/4" Double D
• Natural Steel

Installation Instructions (OAD)