Key Specs

MFG. Part #6100M
BrandMallory Ignition
See more specs

Need To Know

Quick and Easy Returns

Return Policy

Mallory Ignition 6100M Details

For all MALLORY UNILITE distributors, and Conversion Kits. Requires a 1.4 ohms Ballast resistor, Loom resistor, or internally resisted coil. Also can replace the ACCEL Point Eliminator kit module. Includes new connector, grommet, wire tie, screws, and heat sink grease.

Thermalclad

CARB Warning

For race/ off road use only

Emissions warning: this part only legal for sale or use in California for racing (competition) vehicles which may never be used, registered, or licensed for use upon a public highway. Any other use renders the vehicle tampered and not legal for use on California public highways (any public street or roadway, public dirt road, public park, or publicly maintained right of way open to the use of the public for vehicular travel). Violations subject to $37,500 penalty per violation per vehicle, revocation of registration, loss of use on California public right of ways, and proof of correction for tampering. There are similar restrictions and penalties under federal law and the laws of all other states with penalties under federal law of up to approximately $45,268 per tampered vehicle and/or engine.

Mallory Ignition 6100M Specifications

KEY SPECS
MFG. Part #6100M
BrandMallory Ignition
GENERAL
GTIN Code769105122016
Sold in QuantityEach

Ratings & Reviews

5

1 Review

5

1 reviews

5

1

4

0

3

0

2

0

1

0

Filter by Ratings

Unilite module replacement

5.0

7 years ago

Jim

San Diego, CA

Verified

I needed to rebuild an old garage sale Mallory series 37 Unilite distributor. This sensing module is identical in all aspects I can see but considerably less money. Read the instructions and put the white goop underneath the module before screwing it down

Would Recommend

Showing 1 of 1 reviews

Questions & Answers

1 Question • 1 Answer

Good afternoon. I own a 1937 Ford V8 Flathead with a Mallory ignition distributor. This distributor uses "Mallory Ignition points 25042". Now I´m interested in modify this distributor with an electronic module. Which one I need? Thank you for your help. Gabriel Davidovich

by Gabriel

• 7 years ago

1 answer

1 of 1 questions shown

Customer Impersonation Script