Loctite 8060 Tight Anaerobic Gel Threadlocker Sealant 234345

Loctite 8060 Tight Pro Lock is an all purpose anaerobic gel that locks, seals and retains threaded joints. It can lock nuts, bolts, screws and studs and can lock adjusting screws in any position. It is appropriate for thread sizes ranging 1/8 to 1.5" inches. Loctite 8060 anaerobic gel also retains bearings, holds pins and bushings, and seals pipe threads and flanges.

Loctite 234345 (50 mL) is economical by the fact that a small amount does the work of a lock washer, set screw or locking nut. As a substitute for pipe thread sealant, Loctite Tight converts to an insoluble hard plastic after assembly that resists most chemicals, liquids and gases. Similar to other Loctite thread sealant, this product allows for disassembly with standard hand tools. It can be used in temperature areas up to 300° F.

• Gel formula stays exactly where applied with no dripping or waste
• Minimal pre-cleaning required before use
• Functions as a mild thread lubricant during assembly
• Cures to a hard, insoluble plastic for a long-lasting seal and lock
• High resistance to chemicals, liquids, gases
• Combines thread sealing, locking and retaining in one product
• Can be used on header bolts instead of lock wire
• Replaces Teflon tape and Teflon paste for most automotive fittings
• Fasteners remain removable with standard hand tools - no heat needed
• 50 mL tube