IMCA Low Friction Short Arm 3-Piece Spindle w/Wilwood Rotors

Speedway Motors is proud to introduce our exclusive 3-piece Pinto replacement spindle and rotor front end kit for even more value added savings!  Our advanced engineering techniques allowed for a redesign of the spindle in a newly forged, heat-treated steel design that is stronger than the original. These spindles serve as a replacement for cars currently running Pinto/Mustang II setups. The 8 degree pin inclination not only improves handling and driver feel, but also dynamically adds cross weight to the car during counter steering which leads to increased drive off the corner. The shortened, dropped steering arm reduces spacing requirements on outer tie rods and minimizes bump steer while improving overall strength.

Spindle is reamed to accept 7 degree upper ball joints. The unique three-piece construction provides for fast, convenient and affordable replacement of individual components in the event of a crash. These spindles are IMCA/USMTS/USRA approved for use in competition.

• IMCA approved for IMCA Modifieds and Sport Mod divisions
• USMTS/USRA approved
• Forged, heat-treated steel
• Improves front end geometry
• Replacement for Pinto spindle
• Three-piece design for quick, easy replacement
• 10-1/2" Wilwood rotors with 5 x 5" bolt circle pattern
• Short arm design
• Low friction DRP bearings and spacers

 

Kit Includes

(2) Speedway Motors Short Arm Metric 3-Piece Spindle, Body Only

(2) Speedway Motors Pinto Repl 3-Piece Short Arm Spindle Steering Arm, Left and Right

(2) Speedway 1979-Up GM Metric Midsize Spindle Caliper Bracket, Left and Right

(1) 1979-Up GM 3-Piece Metric Spindle Bolt Kit

(2) Wilwood 160-9239LS GM Metric Hub/Rotor, 10.5 Inch, Long Studs

(2) DRP 007 10521S 1979-Up GM Metric Spindle Pre-Load Bearing Spacers

(2) DRP 007-10581 Premium Finished GM Metric Front Bearing Kit

(2) DRP Performance Products 007 10577 Ultra Low Drag Hub Seal

(1) DRP 007-10756 Ultra Low Drag Bearing Grease Syringe, 50 Grams