ICT Billet EM-LS-2FBDY LS Swap Engine Mount Kit LS1 LS3

Drop-in solution for swapping an LS engine into your 2nd Gen F-Body chassis.

Our 1970-1981 2nd Generation F Body LS Engine Mount Kit makes swapping an LS engine into your F-Body chassis easier than ever. Designed as a direct drop in solution, this kit retains the factory small block Chevy (SBC) crankshaft and bell housing location, eliminating the need to modify your transmission tunnel, driveshaft, or linkages. Built from durable steel and finished with a black powder coat, these mounts provide long lasting strength and corrosion resistance for your LS swap project.

• Designed for a drop in LS engine installation in '70-'81 F-Body vehicles.
• Retains factory SBC crankshaft and bellhousing location, avoiding changes to the transmission tunnel, driveshaft, or linkages.
• Engine mounts are built from high quality steel for strength and reliability.
• Ideal for anyone looking to modernize their 2nd Gen F Body with LS power while maintaining factory driveline alignment.
• Upper and lower engine mounts are made right here in Kansas

Fits the following vehicles below:

• Chevy Camaro 1970-1981
• Pontiac Firebird 1970-1981 (Uses front set of holes in subframe)
• Pontiac Trans Am 1970-1981 (Uses front set of holes in subframe)

These LS engine conversion motor mount adapters create clearance interference with the OEM lower passenger side A/C compressor bracket. The factory bracket is not compatible in this configuration. Proper A/C fitment requires either a compressor relocation bracket or an aftermarket accessory drive system utilizing a smaller, short body A/C compressor.