Hooker Headers 8501HKR LS Cast Iron Exhaust Manifolds

As featured on Classic Truck’s Week to Wicked. Watch the transformation here!

Hooker cast iron exhaust manifolds have been designed to hug close to the engine block so they fit into a wide variety of replacement and engine–swap applications. Their contoured design aims the exhaust directly at the exit port for improved flow. Being cast iron means they will provide years of leak–free performance with less under hood noise than traditional headers. Plus, their shorty design means you can route exhaust tubing close to your frame/floor pan for maximum ground clearance. “Hook” up your GM LS engine with Hooker cast iron Manifolds today!

• Intended for all GM LS (except LS7 and LS9) engine swap applications where durability, quiet operation, emissions compliance and leak-free sealing is desired.
• Recommended for strong performance on engines making up to 500 horsepower (For optimum high rpm performance see Hooker long tube engine swap headers)
• Tight tuck design provides universal fit for most popular chassis and a clean traditional muscle car appearance - ideal for GM E-Rod installations.
• Free-flowing for good performance and catalytic converter efficiency.
• Cast from Hi-Silicon-Moly Ductile Iron to provide durability and corrosion resistance.
• 2 bolt exit flange configuration matches 2010 Camaro (also the same as the E-rod exhaust manifolds) which can be used with OE gaskets and fasteners if desired, for an OE quality seal.
• 2.25-inch outlet diameter 
• 304 stainless steel mating flanges included (mating flange fasteners are not included)

Mounted Manifold Specs (GIF)