Holley EFI 112-589 BILLET 90mm LS Throttle Body w/low RPM Taper

This product is engineered to facilitate the installation of a later model, emissions friendly engine into a vintage / classic vehicle. Federal guidelines indicate that an engine swap is allowable if one or more of the following conditions apply:
If there is a reasonable basis for knowing that emissions are not adversely affected as described in the EPA Tampering Policy dated November 23rd, 2020
The resulting vehicle is identical (with regard to all emissions related parts, engine design parameters and engine calibrations) to a certified configuration of the same or newer model year as the vehicle chassis
The vehicle is a uncontrolled vehicle - Vehicles that were manufactured before emission control regulations took effect are called uncontrolled vehicles. Aftermarket parts regulations and anti-tampering laws do not apply to these vehicles
An EO legal engine swap kit is utilized (such as a GM EROD)
The vehicle is being used for Competition Use Only - Racing Use Only Vehicles are vehicles that are used exclusively for competition that are not registered and that may never be used on the street
Consumers are responsible for complying with laws prohibiting tampering, and for ensuring that modified vehicles are operated in a manner that complies with applicable laws.
Motor vehicle emissions standards are intended to help achieve and maintain air quality goals that benefit human health and the environment. The U.S. Environmental Protection Agency, the California Air Resources Board, Environment Canada, and other regulatory agencies prohibit the operation of vehicles on public roads that violate applicable emissions standards. The alteration of certified production vehicles to modify, remove, or render inoperable emissions control hardware or software, known as "tampering" is prohibited by the U.S. Clean Air Act and other laws. Tampering with motor vehicles emissions control systems is punishable by substantial monetary penalties.
Holley is committed to performance parts that allow enthusiasts to modify their vehicles and meet emission requirements. The information provided here is intended to provide general guidance of interest to most consumers. This guidance may not apply to all vehicles or all situations. It is up to each consumer to evaluate his or her own situation and take the steps necessary to comply with applicable laws. The websites listed below have more information about regulations and policies pertaining to motor vehicle emissions. You should also check the regulations applicable to your local area.
EPA Website
https://www.epa.gov/enforcement/epa-tampering-policy-epa-enforcement-policy-vehicle-and-engine-tampering-and-aftermarket
CARB Website
https://ww3.arb.ca.gov/msprog/aftermkt/aftermkt.htm

• Adjustable: Yes
• Billet Color: Black
• Bore Diameter: 90 MM
• Brand: Holley EFI
• Category: Air and Fuel Delivery
• Emission Code: 8
• Fuel Injectors Included: No
• Fuel System Type: EFI
• Gasket Or Seal Included: Yes
• Grade Type: Performance
• Idle Air Control Motor Included: No
• Material: Billet Aluminum
• Mounting Hardware Included: No
• Part Type: Fuel Injection Throttle Body
• Product Type: Throttle Body
• Sub Category: Fuel Injection System and Related Components
• Throttle Body Finish: Black
• Throttle Body Material: Billet Aluminum
• Throttle Body Spacer Included: No
• Throttle Bore: 90mm
• Throttle Diameter (mm): 90mm
• Throttle Position Sensor Included: No
• Warning: California Proposition 65