FiTech 93005 Easy Street EFI 600HP Classic Gold EFI, w/CDI box

The retrofit fuel injection revolution has begun! FiTech is the leading name in EFI conversions for good reason, bringing not only economy to the market but simplicity through design. The switch to fuel injection has never been easier. FiTech’s technology is designed and developed using OEM level engineering and components. All throttle bodies have built-in computers and sensors, reducing the amount of wiring to route in your vehicle. You can run the system on only 4 wires and two sensors! The sensors are OEM style for proven reliability and easy replacement.

Go EFI 600 HP Easy Street Fuel Injection Kit

FiTech Easy Street EFI 600HP System is the perfect solution to bring new life to your build, with just a touch of classic styling. They arrive pre-programmed for an out of the box performance experience and can be set up in a matter of minutes. FiTech Easy Street EFI System features 4 flow matched 80-lb injectors and utilizes Annular Swirl Wet Flow technology for complete fuel atomization. Easy Street series throttle body is finished in that classic carburetor gold and fits on any 4 barrel intake manifold, providing you the best combination of budget-minded, modern fuel injection technology!

Features:

• Classic Carburetor Gold Finish.
• Four FiTech 80-lb flow matched injectors.
• Extreme self learning for wide range super-fast dial in correction.
• Suitable for crate engines and performance engines.
• Pre-programmed wih Bolt-N-Go technology for out of the box
  performance with minimal input required
• Easy tach input,reads tach signal from COIL,HEI, CDI,and many other
  ignition brands (NO TIMING CONTROL)
• For non boosted engines-natural aspirated applications ONLY
• Wide band O2 sensor with mounting kit
• On board fuel pump driver with PWM
• Annular discharge design
• HandHeld tunning module for performance tunning
• 1 fan control
• E85 compatible (30% reduction in HP capacity of fuel system and EFI)

FiTech Go-Spark CD Ignition

FiTech EFI is excited to extend their ignition offerings with the new Go-Spark CD Ignition! The all-new Capacitive Discharge Ignition will deliver high powered sparks from idle to top rpm to improve the combustion event and power output of your engine.

The Go-Spark CDI was designed for both EFI equipped or carbureted engines and features a microprocessor to manage the spark delivery. The ignition, which is assembled in the USA, produces a series of multiple sparks below 2,500 rpm to improve starting, idle quality and throttle response. At higher rpm, the CD technology continues to deliver full energy sparks through racing rpm to ensure complete combustion of the fuel mixture. 

The Go-Spark CDI is designed for 4, 6, and 8-cylinder engines equipped with a distributor. It accepts the trigger signal from an HEI, amplifier, points, or 2-wire non-magnetic pickup distributors. The tach output signal, which is also used to trigger a FiTech EFI system, is a 12-volt square wave signal that is divorced from other circuits to provide a clean, perfect signal.

Not legal for use on pollution controlled vehicles. This system is designed to be installed into vehicles that do not require emission controls.

Not legal for use on pollution controlled vehicles. This system is designed to be installed into vehicles that do not require emission controls.

5213005 Instructions (PDF)

Quick Start Guide - Handheld Controller (PDF)

Handheld Controller Feature Definitions (PDF)

Go-Spark CD Ignition (PDF)