This Edelbrock throttle linkage rod kit is a non progressive adjustable throttle linkage rod for Edelbrock 94 carburetors. They are available for dual (uses # 1032 linkage) and triple (uses # 1034 linkage) carburetor set-ups. Edelbrock 94 carburetors are equipped with an extended length throttle shaft, making these kits a bolt-on to Edelbrock 94 carburetors.
Photos above showing 3 carburetor set up are for reference only to illustrate linkage concept on the 3 carburetor combination. 2 carburetor set up has the same linkage format with one less carburetor and linkage arm combination.
Note: Photo above calling out part contents from the instruction sheet has the 3-carb linkage kit # 1034 contents shown for reference. Kit # 1032 contains one less Throttle Linkage Arm, Throttle Linkage Lock Screw, Swivel Stud, Swivel Stud Set Screw, Swivel Stud Washer and Swivel Stud Cotter Pin than the quantities indicated for the 3-carb linkage kit # 1034 shown above.
Photos above showing 3 carburetor set up are for reference only to illustrate linkage concept on the 3 carburetor combination. 2 carburetor set up has the same linkage format with one less carburetor and linkage arm combination.
Note: Photo above calling out part contents from the instruction sheet has the 3-carb linkage kit # 1034 contents shown for reference. Kit # 1032 contains one less Throttle Linkage Arm, Throttle Linkage Lock Screw, Swivel Stud, Swivel Stud Set Screw, Swivel Stud Washer and Swivel Stud Cotter Pin than the quantities indicated for the 3-carb linkage kit # 1034 shown above.