Double End Carburetor Linkage, 9 Inches Long

Minor fittment modification for Henkyo 94 carbs.

I had to slightly open the ball hole to get the Henko carb ball to insert. The springs seem too long. The length measurement seems to be from opening to opening, and not to the area in the slot where the ball will sit. The center ball might need a dimple or flat spot filed onto the rod to get it to hold position. The lock nut on the center ball immediately stripped when snugging it up. All minor problems if you're building a car. I was able to cut and re-thread one end to get the length correct. Although it would have been nice for it to just snap on and fit, I did not expect a direct fit on a vintage dual carb intake, with two Japanese 94 styled carbs.

I would recommend this product.

Once I got the linkage over the carb and throttle ball ends it adjusted to exactly what I needed.

Dual Stromberg97 linkage for Flathead

Great looking and functioning part

I would recommend this product. Great quality!

Buying this product was easier than makingone.

It can be made to work

The center ball likes to come loose, and the end cups has a springs that is too long and requires a bunch of fiddling

Perfect

Installed on a dual 2-barrel and looks great!

no, but it was exactly what i needed and would buy it again

its on a flathead ford with two stromberg 97 carbs

Great item, well made

I found my sweet spot for the middle connector, slotted a notch in the rod the size of the set screw, set the screw with threadlocker. This will prevent the mid connector from sliding - I recommend this

i would recommend this to my friends

look/works good

Great product. I would purchase this product again.

I used the linkage to connect my chokes on my dual 97 Stromberg. I had to cut it off to make it shorter and then rethread that end but it worked perfect.