Corvair Pitman Arm, Zinc Plated and Puller Tool

 

Pitman Arm

This is our forged 'new design' Corvair pitman arm. It measures approximately 7" end to end, approximately 5-3/8" from the center of the big hole to the center of the small hole. The arm has a side-to-side offset approximately 1-7/8". The small hole accepts the early Ford style tie rod end (such as our 910-02909) and it is half tapered from both sides to allow the drag link to be mounted from either side (illustrated in second photo as shown).

 

Pulling Tool

This two-piece tool set makes it easy to separate tie rod ends from the tie rods and separate pitman arms from steering gear. It includes two different length center screws to fit a wider range of vehicles.

Any automotive specialty tool makes an automotive repair or maintenance task easier, but Powerbuilt takes the concept of ‘help' a big step further. Every package comes with professionally written usage instructions and photos that take you step by step through proper tool usage.

• Drop forged and heat treated chrome vanadium steel for strength
• Fine threaded center screws for maximum torque
• Includes short and long center screws to fit a wide variety of vehicles
• Meets or exceeds ANSI standards
• Lifetime warranty