If you still need a front axle for your pre-2008 Total Performance® T-bucket, you had better read this. The Total Performance® T-bucket spindles were a hybrid that combined Econoline kingpins, early Chevy bracket mounting tabs and early Ford wheel bearing surfaces. Unfortunately these spindles are no longer being manufactured. Speedway has these special built radius rods that will allow you to use our Ford or Chevy tubular axles.

Specs

Overall length is 32 ½”
7/8” O.D.
5/8” x 18 threads

CA Prop 65

Specifications

KEY SPECS
MFG. Part #	Select Finish to see
Brand	Total Performance
Overall Length	32.50"
Tube O.D.	.875"
Finish	Select Finish to see

GENERAL
Thread Pitch	5/8 x 18
Sold in Quantity	Each

Ratings & Reviews

2 Reviews

Overall Assessment

Customers appreciate our product's quality and functionality, particularly as a drop-in replacement for bent sets. The usability of the hairpins is praised - users don't need to tap the threaded areas due to effective pre-chroming. The material quality sets our hairpins apart, striking a balance between robust steel and easy-to-tighten aluminum. Customers have indicated they would buy our product again, showing preference over potential competitors. Despite requiring only an Allen wrench for tightening, the product is still seen as dependable and safe.

Write A Review

2 reviews

Filter by Ratings

Sort Reviews

I would buy this product again

5.0

2 years ago

Gearhead

Rochester ny

Verified

I used these hairpins on the front of my 1923 t bucket.i liked the fact that I did not have to run a tap throght the threaded areas as they plugged the properly before the chroming prosses

Needed to replace a bent set

5.0

6 years ago

Bad Bob

Mesa AZ

Verified

I bought these because the ones on my rebuild were bent and I wanted to keep the TP chrome front spring and drop axle assembly, so I needed a drop-in replacement. The old steel hanger bolts were drilled for safety wire, but these just have an aluminum bolt that only takes an Allen wrench to tighten. I'm hoping Locktite is adequate for the job.

Would Recommend

Showing 2 of 2 reviews

Questions & Answers

6 Questions • 6 Answers

Sort Questions

Concerning Part # 7151331. My radius rods measure 34 inches. 7151331 measures 32.5 inches. What were the measurements Total Performance's originals. I cant find exact replacements and don't really want to re-do rear mounting point. If I end up making my own, what wall thickness of DOM 7/8" tubing should I use?

by Mark

• 8 years ago

1 answer

View Answer

Installed length? What is the installed length of these radius rods? Are they like four-bar links that measure 3" longer installed than the end-to-end without rod ends?

by Opus

• 11 years ago

1 answer

View Answer

front tube spacing measurment please......distance center to center?

by thintin

• 12 years ago

1 answer

View Answer

Are they sold in a pair?

by SKirby

• 12 years ago

1 answer

View Answer

will these bolt to your radius rod bracket item number 91635012 that has the 5 inch hole spacing

by Craigme

• 13 years ago

1 answer

View Answer

DO THESE RADIUS RODS HAVE THE SAME 5/8 THEADS ON ALL 3 AREAS? ALSO ARE THEY RIGHT OR LEFT HAND THREAD AND RIGHT OR LEFT, IS IT THE SAME FOR ALL THREE.

by JIM

• 15 years ago

1 answer

View Answer

6 of 6 questions shown