BendPak 5175162 Four-Post Vehicle Lift 27,000 Lbs

If you need a bigger, better four-post lift that can handle a 27,000-lb., Class 7 semi-truck, you need the HDS-27. Bigger sheaves and beefier components carry on our legacy of dependability. If your shop services commercial and/or municipal vehicles, this lift is practically mandatory.

This is where our car lifts really step into the next level of lifting. While the HDS-18E is an entry-level lift in the medium-duty truck category, the HDS-27 is well-suited to take your business well beyond the needs of most private drivers. This garage lift brings you into the realm of construction equipment, commercial flatbed trucks, concrete mixers, garbage trucks, buses, etc.

Every BendPak four-post lift, regardless of lift capacity, is made to exacting standards and gets the job done without undue strain or pain on the equipment. When we rate a truck lift at 27,000 lbs., that means anything at or under that weight limit is a cinch for our lifts to handle. We superbly over-engineer everything, so you can keep the “biggest and baddest” commercial and municipal vehicles up to code and ready for the next great haul.

• 27,000-lb. lifting capacity
• CE Approved and Certified. Meets or exceeds the standards prescribed by European Standard EN 1493
• Supersized 12" diameter cable sheaves
• Galvanized lifting cables
• Grease nipples
• Single hydraulic under-runway cylinder
• Integrated flow restrictor
• Durable powder coat
• Spring-loaded safety locks
• Second lock system on constant guard
• Fully enclosed lifting cables
• Multiple adjustable height locking positions
• Maintenance-free electric hydraulic power system
• Conveniently positioned operator controls
• 12" x 12" base plates
• Non-skid runways

Due to the shipping weight and dimensions of this item, it is required that it be shipped to a business address that will have either a receiving dock or fork lift at the delivery destination to allow for the item to be unloaded from the truck/trailer at the time of delivery.

BendPak Four-Post Vehicle Lift Installation and Operation Manual (PDF)

BendPak Delivery Requirements (PDF)

BendPak Delivery Information (PDF)

Capacity

Lifting Capacity*- 27,000 lbs.

*Max Capacity / Front Axle - 13,500 lbs.

*Max Capacity / Rear Axle - 13,500 lbs. 

Rise

A - Min. Runway Height: - 83.5” 

B - Max. Rise: - 60” 

C - Max. Lifting Height: - 68.5” 

Time to Full Rise: - 75 seconds

Outside Dimensions

D - Overall Width: - 154” 

E - Outside Length: - 257” 

F - Overall Length: - 297” 

G - Height of Columns: - 93” 

Inside Dimensions

H - Width Between Columns: - 134” (3,404 mm)

I - Drive-Thru Clearance: - 109” (2,769 mm)

Runways

J - Runway Width: - 22” 

K - Length of Runways: - 263” 

L - Width Between Runways: - 38”  or 56” 

M - Runway Centerline: - 60”  or 78” 

N - Outside Edge of Runways: - 82” or 100” 

Minimum Wheelbase

Rated Capacity: - 185” 

75% Capacity: - 160” 

50% Capacity: - 135” 

25% Capacity: -110” 

Locking

Locking Positions: - 9

Lock Spacing: - Every 6”

Power Unit

Motor: - 220 VAC / 60 Hz. 1Ph.

Noise: - 45 dB