AutoMeter Oil Pressure/Temp Sender Adapter LS Engine Fitting Kit

Both the LS Series oil pressure sender fitting and the LS Series water temperature sender fitting are 1/8" NPT and are installed in place of the OEM sender. When installing aftermarket gauges, the OEM oil pressure sender is not required by the PCM and may be replaced by the aftermarket sender of your choice. The water temperature sending unit to be installed in your passenger side cylinder head.

• (1) Auto Meter LS Series Oil Pressure Sender Adapter
• (1) Auto Meter Temperature Sender Adapter Fitting
  • Thread Pitch: 16mm-1.5 to 1/8" NPT
  • Notes: Includes crush washer
  • Thread Pitch: 12mm-1.5 male
  • Overall Length: .94"
  • Thread Pitch (2): 1/8" NPT

Note: I.D. of this adapter where the sender probe will go through is .309 and would require drilling to approximately 5/16" or .312 for a Stewart Warner sender to pass through.