ACCEL 140021 Ignition Coil, SuperCoil, Dodge/Jeep MAGNUM 1990-1997
- This item ships directly from the manufacturer. It may take an additional 3 business days for Accel to ship this item.
- This item ships via Ground Shipping only. Expedited and Air shipping options are not available.
InfoEngineered with optimized low resistance, high turns ratio windings around an M36 high silicone magnetic steel C-core for higher energy and voltage outputs. Results in
quicker starts, improved idle quality, crisper throttle response and more high RPM power. Compatible with late model Dodge/Jeep J-TEC computer controlled ignition system and MOPAR Performance ignition computers. Direct bolt-in, plug-in replacement. Can also work with an ACCEL, Mallory, Crane, Holley or MSD capacitive discharge ignition systems. Special high temperature epoxy resists shock and vibration, while increasing thermal conductivity. Brass coil wire contact increases energy transfer efficiency and resists corrosion better than aluminum. High dielectric strength “ACCEL Yellow” over molded housing.
This ACCEL SuperCoil ignition coil fits Dodge “Magnum” Truck / Jeep 1990-97.
- 10-15% More Energy
- Direct Plug In Replacement Direct OE Fit
- Advanced Bobbin Technology
- Standard Motor Products SMP Uf-198
- MSD 8228
More Like This
PerTronix 40001 Flame-Thrower Coil, Chrome
MSD 8203 Blaster 2 Ignition Coil w/ Resistor
MSD 8225 HEI High Performance Direct Replacement Coil
Speedway High Performance HEI Coil
PerTronix 60115 Flame-Thrower HV Coil, 1.5 Ohm
Joe Hunt Sprint Car External Coil
PerTronix 60104 Flame-Thrower HV Coil, 0.45 Ohm
Pertronix 45011 Flame-Thrower II Ignition Coil, 6 Volt, 0.6 Ohm
MSD 8202 Blaster 2 Ignition Coil
MSD 8240 Midget Coil Pack