7 Inch Cast Aluminum Economy Shifter

You literally cannot go wrong for the price

Bought as a twin stick for a dual transfer case setup I built. The casting is a little rough but not sharp. I enlarged the holes to exactly 5/16" and the same size bolt, took almost all the slop out. This is a freakin sweet product and you literally cannot go wrong at the price.

Worked perfect just like it should! Ver satisfied

I used these to convert my three on the tree to a floor shifter. Great cheap alternative. Looks great and operates great

I would by this product again

It is the shifter for my 1980 Ford pickup

Good product for the price.

I am actually using this to actuate some hydraulic valves. They are simple levers, not much to screw up. Castings aren't precision, but not terrible. They serve the purpose for me, and were inexpensive.

Worked perfectly for me

I was looking for a simple low cost easy to use shifter that I could modify slightly and this worked perfectly. The B&M shifter I had was a hunk of junk

You couldn't make these for $20 well worth the money

These were used in mini rod tractor application. They fit good.

levers too short does not fit stock rods

Had to grind rod hook up points to fit stock rods,should be longer to reach easy,lower half should be longer so shift rod don't hook up on a had angle,Bottem line is manufacture was just too cheap to make the whole thing 6" longer to make it a better product

great buy

Good shifter for the money comes with holes not drilled in lower legs which helped make it stronger.

Great durable shifter

Easy installation

Nice quality part at a reasonable price.

Quality part, without steep price.