1953-56 Ford F100 Pickup 3 Inch Wider Rear Fenders

Beware, NOT 3" wider.

The quality is OK, but they are in fact, only 2 inches wider than factory, compared to a cherry original at the point where they say their overall width is (13.5"). Factory measures 11.5". Quite the setback when you have already set up custom bedside widths with close margins, in anticipation for an extra inch on each side

I would buy again and refer to a friend

Replaced stock fenders with wider for wide tire clearance.

I would buy this again but only if I have to

These fenders are great compared to what I would have to go through to make them. What was a drag was I had to pay a third of the price in shipping. Still the fenders are way cool man

Good looking fenders

Adds that fat fender look you want if you're running a wider wheel/tire setup.

Great product

I put these on my 55 Ford F100 and they look great and are wider than stick

These fenders were perfect.

They added the wider stance I was looking for to my project.

Nice quality

They look good

Not terrible, not fantastic. Rate them a 3.5 / 5

Considering its fiberglass they are a pretty decent product.expect to have to do some work, no pre drilled holes. they are wavy as expected, need tons of bodywork and priming. youll have to glass in the stiffener mount. theyre raw underneath so will need undercoating,had to force them to line up with mounting holes which was the biggest bummer..they are as expected , for the width you gain as long as you expect to have to do some work they are definitely worth the purchase..I would purchase these again and reccomend them to my clients.

I would buy these fenders again

Be aware that what you're getting is not a product that you can just scuff with sandpaper and paint. In my case I had to skim coat them and then block sand them. They came with a white sandable gelcoat which is a plus. I would give these fenders a 7 out of 10

Fitment

Having a little problem with fitment.Are there any pictures installed on F100?