1949-1953 Flathead Generator Cover, Stainless
6.00" Overall Width, 15.25" Overall Length, Stainless Steel, Polished
Speedway's stainless steel generator cover is easy to install and is a sure way to add a little flash to your detailed Flattie without breaking the bank.
This 1949-1953 generator cover has two holes to fit over the wire connector screws on the side of your generator. These generator covers include a stainless steel strap to hold the generator on its bracket.
- 6” wide, 15-1/4” long overall.
- Polished stainless steel
- Fits generators with a length of 6”, and circumference of up to 15-1/4”
- 2 hole with strap
Alignment pin holes at 1.50” for narrow 3/8" pulley, and 3/4" for 5/8" pulley. Terminal hole provisions at rear next to cooling slots at about 8 o'clock location (as viewed from the front).
- Get FREE shipping when your order includes this item and exceeds $99! Ground shipping only in the contiguous US.
More Like This
Q & A
Pat talks about our red solid core spark plug wire and rajah ends.
Looking for an easy performance upgrade to your ignition system? MSD's line of Ignition Control Boxes offer extreme improvements to drivability and high rpm applications. Here's a look at the differences between the 6 series line-up.
A routine weekly maintenance checklist to perform between each race in order to keep a clean and efficient race car at the track.
Check out our one wire alternator conversion guide. We cover GM 1 wire alternator wiring as well as Ford and Chevy. Learn about pulley ratio and charging too!
Brief review of the different types of Ford alternators and regulators available through Speedway Motors.
Follow along as our Expert details his restoration methods for making an engine in an old 1954 Chevy look new again with a little cleaning and refinishing.
Learn about GM alternator identification in our guide. We cover GM 3 wire alternators, 1 wire alternators, and externally regulated so you know what to choose.