1-1/2 Inch Aluminum Remote Fuel Cell Filler Neck Flange Assembly

This was exactly what i needed and installed perfectly.

Exactly what i needed, works perfectly

Great product worked perfectly for my setup

Mounted my fuel cell under my bed floor and used this to put a filler in the bed floor and worked out perfectly

I would recommend to anyone to add remote fill feature

replaced the center mounted gas filler cap that was factory installed to add remote filler hose and gas cap on my 1948 F-1

Can be made to work, but need improvement.

Main thing is this fixed the problem of a corroded out aluminum fuel tank filler neck in a 1980s Bayliner fishing boat. Rubber gasket that comes with it is junk. Really needs rubber gasket with cloth fibers in it to keep the gasket from just swelling out when under pressure. Also needs same rubber with cloth fibers gaskets for each bolt head. Made new gaskets with rubber/paper gasket material and replaced the all too small metal washers with nylon washers with bigger OD. Would be a better product if the bolt pattern was moved inward about 1/4" (6mm) to give a little wider outer gasket sealing area, or perhaps making the OD of the part that much wider. Rather pay $5.00 more for a properly made part than to spend two tries to get the part to seal up.

Yes. Great quality

Just what i needed.

59Chevy

Worked well for the plastic tank.

Great

Worked as it should ,

Great Product

Bought a new tank for boat fill in wrong location UGH!! Bought this fill...problem solved. Great product Excellent service. I will be purchasing another for my other tank. Thank You!

Worked great for my tank installed under the bed in my 52

Worked great

Would use again

Very nice piece. Had to open up slit on retainer a little to fit Polly tank. Overall very happy. No leaks!!