No items in Shopping Cart
Our universal fit Deitz-type 7" headlights feature chrome housings and a 12 volt bulb with both Hi & Low beams. "Drilled" mounting stud measures 1/2"-13. The pre-wired plug has 3 wires with 6" leads.
Choose Standard (Sealed Beam) or Halogen bulb.
very nice piece well crafted great chrome worked great but the bolt for the headlight mounting point was short and i barely caught 2 threads and had to shave down the headlight mount that i also bought here...but besides that they are great
Used them on my T Bucket.
Bought these for my T Bucket project, Was expecting something much less. These head lamps took 5 minutes to install and wire up, and from what i've seen on other T Buckets, they look just as good as the [$] pairs.
I have purchased these lights many times for customers hot rods , street rods , T-Buckets , rat rods and for my own use , they look good , fit good and work great , many compilments .
I bought these lights to install on a club car 32 roadster cart that I am restoring. They worked out and look great.
Get your questions answered by the community. Ask or answer questions below.
hi again do any of the headlights include a parking lt as well Thanks Glen
Asked on 5/4/2011 1:02:20 PM by Barry from Lindenhurst New York
Our Dietz type headlights do not include a parking lamp. They only have provisions for high beam and low beam headlights. For an accessory parking lamp, you may want to consider our 316-0176 or 316-0171 or 316-5052 universal specialty lamps.
Answered on 5/5/2011 4:10:56 AM by Wyatt from Speedway Motors
is the bolt long enough to go trew fender and is there a rubber piece for bottom
Asked on 7/4/2011 4:48:16 AM by Barry from Lindenhurst New York
The Dietz headlights have sufficient length mounting studs for most applications and the threaded stud extends approximately 2” below the flat mount base. In many cases the customer or builder shortens the stud for a cleaner installation. The flat mount base can be removed and the light mounted in a headlight bar or stand if desired. A rubber gasket or seal is NOT included for the base.
Answered on 7/6/2011 9:22:34 AM by John from Speedway
Can this housing be used with "Replacement Headlights w/ Clear Turn Signal" part number 9106127
Asked on 10/27/2011 4:12:38 AM by Chuck from Lindenhurst New York
Part number 91101001 These lights accept most aftermarket 7” headlight such as part number 9106127. With variations of the mounting flange thickness on the replacement lights in some cases some of the plastic material may need to be removed to allow the chrome retainer bezel to fully seat on the headlight housing.
Answered on 10/27/2011 8:58:45 AM by John from Speedway
is this for a pair of headlights? or just a single light?
Asked on 12/25/2011 2:56:50 PM by Barry from Lindenhurst New York
These lights are sold as a pair
Answered on 12/27/2011 6:58:58 AM by Jason from Speedway
Do you have a question about this product?