1969 GMC G25/G2500 Van Accessory Drive

Jeff demonstrates how to install the front runner drive system by Vintage Air in his 1967 Chevelle project car all while maintaining a simple, factory fresh look.

When Tyson picked up his '69 SS396, all the trim was in the trunk. We follow along as he installs the shiny stuff to finish out his project.

In this article Jeff talks about some very helpful tricks to keep your projects safe and easy to work on. Learn about some of the tools and products Speedway offers to help!

Follow along as Jeff installs Mr. Gasket aluminum finned valve covers and gaskets to his iron-head engine. Learn how to prep the covers for a fresh coat of engine paint!

Learn the installation process of a drive shaft loop kit in a 1967 Chevelle. NHRA requires a driveshaft loop if you're going to run slicks on the drag strip!

To keep this project moving forward, Jeff installs a gear reduction mini starter on his big block. See how to apply the mini starter on 153 or 168 tooth flexplates.

In this Tech Tip, John answers a customer concerns about adding additional drop to his 1960-1972 Chevy truck.

This drag and drive '49 Mercury is not at all what you'd expect from a chopped Merc. It's part custom, part hot rod, and built to do it all.

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.

See how this natural fitting Speedway Motors stainless steel coolant expansion overflow tank is installed in a 1967 Chevelle. Learn tips on how to prep the canister for paint work and recommended paint brands to use for this project.