1969 Dodge M300 Accessory Drive

Jeff demonstrates how to install the front runner drive system by Vintage Air in his 1967 Chevelle project car all while maintaining a simple, factory fresh look.

When Tyson picked up his '69 SS396, all the trim was in the trunk. We follow along as he installs the shiny stuff to finish out his project.

Learn the installation process of a drive shaft loop kit in a 1967 Chevelle. NHRA requires a driveshaft loop if you're going to run slicks on the drag strip!

Mike Earley fell in love with Chevelles when he was a little kid. Now he's lucky enough to own one of his own with a few unexpected tricks under the hood.

Tyson Jurgens almost sold his '69 Chevelle SS, but something in his gut told him not to. In this episode of Employee Rides, we find out more about what makes this car so special.

Jeff is the Speedway Motors Retail Store Manager, and his '69 Chevelle is as nice as it is fast.

This drag and drive '49 Mercury is not at all what you'd expect from a chopped Merc. It's part custom, part hot rod, and built to do it all.

Jeff's 1967 Chevelle project undergoes prep for a Dakota Digital Dash System. Keep a factory style dash with this wide sweep speedometer. Learn how to mount and wire modules for the gauge system, gear shift indicator, GPS speedo sender and auxiliary.

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.