1969 Chevy P30 Van Ignition, Charging and Starting Parts

Little is thought of your engine’s starter until it refuses to turn your engine over at the worst possible moment. Today’s powerful mini starters can crank the biggest engines with ease. Learn how in our buyer’s guide.

It's alive! Our 1968 C10 truck project is one step closer to our first drive. In this episode, our old truck finally comes to life with a cammed junkyard LS.

Upgrading to electronic ignition is a huge improvement in performance, reliability, and lower maintenance that you can add to just about any engine your project may be running. Learn all about your electronic ignition choices in this buyer's guide.

Bringing an old Mopar back to life isn't always a breeze. Fortunately, MSD has come up with a solution for those outdated and unreliable points-type ignition systems. Find out how to install a MSD 8386 distributor and MSD 5531 spark plug wires

To keep this project moving forward, Jeff installs a gear reduction mini starter on his big block. See how to apply the mini starter on 153 or 168 tooth flexplates.

Speedway Tech Zach discusses the Pertronix Ignitor III conversion in his '55 Chevy.

Learn how to keep your starter cool using a heat shield. Read the steps and parts necessary for the installation.

Jeff demonstrates how to install the front runner drive system by Vintage Air in his 1967 Chevelle project car all while maintaining a simple, factory fresh look.

Instructions on how to install a PerTronix Ignitor Kit in an old flathead distributor for a flathead V8.

In this episode, Project Chevelle takes a big step in its muscle car transformation. It's out with the little old 307 and to the dyno with our new 383 from BluePrint Engines!