1968 Chevy G10 Van Engine Service

In this episode of our C10 build series, we swap cams in a junkyard 5.3 and make surprisingly big power.

In this episode of our '68 C10 project, we hit a couple big milestones. The engine goes in and we hit our first car show. It may be just a rolling chassis, but we're mighty proud of how far we've come.

Take a look at a few of the rare and wonderful Chevy engines in the Museum of American Speed!

It's alive! Our 1968 C10 truck project is one step closer to our first drive. In this episode, our old truck finally comes to life with a cammed junkyard LS.

Derek kicks off his 55 Chevy rebuild with a fresh small block.

Old trucks are just meant to have manual transmissions. They're made even better with a modern overdrive like a Tremec TKX. Watch our C10 manual transmission conversion on an LS-swapped '68 to see just how easy it is to row your own gears,

We're kicking off the build of our custom 1968 Chevy C10 short bed Fleetside pickup truck with a video showing our humble starting point and a general guide on '60-'72 C10 truck features and history.

In Episode 3 of our C10 build, we install a front suspension kit and finally have a rolling chassis!

We've come a long way on our '68 C10 project, but we still have a long way to go. Watch as Kevin and Joe discuss where we're at and where we're going.

It's done! Well, at least for now. Check out the conclusion of our 1968 C10 pickup truck build!