1968 Chevy C30 Wheel Lug Pattern Tools

In Episode 3 of our C10 build, we install a front suspension kit and finally have a rolling chassis!

Next up, Jeff replaces the brake lines on his Chevelle. See how he uses a double flaring brake line tool by Titan Tools to create double flares. This tool is sure to make your life easier, and save some time!

Learn how to restore vintage 200S mag wheels. These steps ensure a smooth and successful restoration and installation.

In this restoration project, find out how to remove rusted floor pans and install new sheet metal on a 1963 Chevy Impala. Investing in the proper tools is essential in getting the job done right!

From a mild leveling to slammed and “in the weeds” there are several options to lowering a C10. We discuss the options in our ’67-’72 C10 lowering guide.

We've come a long way on our '68 C10 project, but we still have a long way to go. Watch as Kevin and Joe discuss where we're at and where we're going.

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.

In this Tech Tip, a customer asked about a discreet style trunk latch for his 1932 Ford.

It's alive! Our 1968 C10 truck project is one step closer to our first drive. In this episode, our old truck finally comes to life with a cammed junkyard LS.

Follow along as we give our C10 truck project a much needed dose of suspension travel with a bolt-on C-notch kit.