1968 Chevy C20 Distributorless Ignition System

Jeff demonstrates how to install the front runner drive system by Vintage Air in his 1967 Chevelle project car all while maintaining a simple, factory fresh look.

Follow this detailed guide on installing a FiTech EFI system in a '67 Chevelle. Learn helpful tips along the way including how to route the blue trigger wire away from the coil and ignition system.

In Episode 3 of our C10 build, we install a front suspension kit and finally have a rolling chassis!

Next up, Jeff installs a custom exhaust system in his '67 Chevelle. See how he applies tailpipe tips and incorporates exhaust cutouts during the process.

It's alive! Our 1968 C10 truck project is one step closer to our first drive. In this episode, our old truck finally comes to life with a cammed junkyard LS.

See the final steps of installing a custom exhaust system on a '67 Chevelle. Learn some tips on how to offset and install the exhaust U bend tailpipe.

In this episode of our C10 build series, we swap cams in a junkyard 5.3 and make surprisingly big power.

We've come a long way on our '68 C10 project, but we still have a long way to go. Watch as Kevin and Joe discuss where we're at and where we're going.

In this episode of our '68 C10 project, we hit a couple big milestones. The engine goes in and we hit our first car show. It may be just a rolling chassis, but we're mighty proud of how far we've come.

Our project '68 C10 had some pretty rough sheet metal. In this episode, we go from a scary, rusty mess to a complete cab ready for bodywork.