1967 Jeep Commando Push Button Switches

Follow this guide on how to mount a single electric puller fan in a '66 - '67 Chevelle. Learn tips on taking measurements and installing a rubber spacer to prevent the fan from rubbing.

Jeff tackles the installation of the Lokar Muscle Car Shifter inside of a factory stick-shift floor pan section. This product won a "Best Interior Product" Award at the SEMA show in 2016.

Follow this guide to see how Jeff upgrades his power steering system. Learn how to cut and assemble a -6 AN hose and fittings for optimal connection to the power steering pump.

Jeff installs a Wilwood 12.19" Front Disc Brake Kit to his 1967 Chevelle. Read more on the caliper bracket assembly and brake rotor setup.

Learn the installation process of a drive shaft loop kit in a 1967 Chevelle. NHRA requires a driveshaft loop if you're going to run slicks on the drag strip!

Next up is the suspension on Jeff's 1967 Chevelle project. Learn how to properly disassemble and remove components, such as the spindles and brakes. See tips on replacing the control arm bushings and using the right tools to get the job done.

Jeff walks through how to install an EFI filter for his fuel system. See how to assemble conversion fittings to accurately plumb the fuel lines and tips on fuel line routing.

Follow this restoration guide as Josh breathes new life back into his Pontiac engine.

Jeff converts his 1967 Chevelle manual brake system to power by installing a Delco booster kit. Learn how to make the master cylinder more resistant to brake fluid and a few tips for an easy install.

To keep this project moving forward, Jeff installs a gear reduction mini starter on his big block. See how to apply the mini starter on 153 or 168 tooth flexplates.