Transmission Mount Parking Brake Boot with Billet Ring, Polished

• 1/4-inch thick 6061-T6 billet aluminum parking brake boot ring CNC machined with 3D reliefs
• Oval design works with most aftermarket parking brake levers
• Fits transmission mounted parking brake levers
• Great for when upgrading from under dash parking brake setup
• Offered in bare satin, highly polished, and black anodized finishes
• Includes 1.5mm thick flame retardant leather-look universal boot
• Handbrake boot top opening accommodates most parking brake levers
• Comes complete with stainless hex drive flathead screws and nylon locking nuts
• Matching shifter lever trim ring and boot kits available

Complement Any Interior with Our Billet Aluminum Parking Brake Bezel

Most pre-70s model cars and especially trucks used either an under dash parking brake pull lever or a foot operated parking brake setup. Many hot rods had big, ungainly parking brake levers coming up through the floor as well. Many enthusiasts look to ditch these archaic parking brake setups to provide more room in the foot well, or more room for a clutch pedal, and so forth. Adding an aftermarket parking brake lever on the floor between the bucket seats is fairly common, but now you can dress it up with our great looking billet aluminum parking brake bezel trim and leather-look handbrake boot!

We have designed a complete line of 6061-T6 billet aluminum parking brake bezels available in a brushed finish, polished finish, and black anodized. These parking brake bezels are designed for transmission mounted parking brake assemblies that pass through the floor in a more vertical fashion. If you are using a more horizontal floor mount style of parking brake lever, we have floor mounted parking brake bezel kits designed to work with that setup too.

Ready To Install with a Pre-Sewn Leather-Look Handbrake Boot and Stainless Hardware

At just 1/4-inch thick and machined with a light three-dimensional line of ball milled pockets/recesses into the surface, this parking brake boot ring will work with both stock and custom interiors. The included parking brake lever boot is made from a flame retardant material with a black leather-like grain texture. The parking brake boot comes pre-sewn and features reinforced stitching at the parking brake lever opening. The parking brake lever opening can accommodate both round and flat parking brake levers. The included bright stainless steel hex drive flat head screws secure the parking brake boot ring and universal parking brake lever boot to your car’s floor with the matching nylon locking nuts and flat washers.

The parking brake boot bezel is generously sized to clear most transmission mount parking brake levers. The oval parking brake bezel is sized at  6-1/4” x 2-3/4” OD with a 5” x 1-1/2” ID. Matching floor shifter bezel kits are available in all three finishes in both rectangular and circle bezel designs.