Tilt Column Installation Kit, GM Applications 69-94

Steering shaft is 3/4" O.D round material with a 1" long 3/4" "DD" design on each end. (see note below)

This steering shaft entails:

• 1018 Steel
• 3/4" DD configuration on each end and will be a 3/4" Weld-on if cut to length
• Excellent for steering shafts or other uses 
• Order desired length

NOTE: This DD shaft is only milled with flats on both ends for 1" of length of the shaft. It is not milled the entire length of the shaft and therefore, can not be cut to length unless it is going to be welded to a 3/4" round or has new flats milled into the end. Please see Flaming River DD shaft if fully machined DD shaft is required.

U-Joint 1 Inch Ididit DD to 3/4 Inch DD

Tech Tip #1: When using more than two universal joints in a system, a support heim must be used.

Tech Tip #2: Increasing a U-Joint's angle of operation beyond 30° dramatically increases the stress on the joint, weakening the whole steering mechanism. If a greater angle is needed, add another u-joint.

3-Bolt Steering Wheel Adapter, GM Applications 69-94

This steering wheel adapter allows you to put an aftermarket 3-bolt steering wheel on a 1969-1994 GM, Ididit or Flaming River non-telescopic steering column. Horn button not included. Includes black metal cover, horn button spring, spacer ring, plunger spring, lead wire and three mounting bolts.

• 2-3/8" I.D. holes for the horn plunger lead wire.
• Standard 3-bolt pattern for custom steering wheels in 1/4" fine thread.
• Horn button isolator plate is 2-15/16" O.D.

Included in this Kit:

(1) 3-Bolt Steering Wheel Adapter for GM Applications 69-94

(1) U-Joint 1" DD to 3/4" DD

(1) DD 3/4" Steel Shaft Available in: 18, 20, 22, 24, 26, 28, 30, 32, 34, and 36 inch lengths

91032481 Instructions (PDF)

Adapter Application Chart (GIF)