T Bar Mockup Kit for Mustang II Front Suspension

Worth the investment

Using the T-bar mock up kit to set ride height of front suspension to save the wear and tear on coilover shocks while continuing my build

Coilover saver

Use in place of coilover in mustang II IFS while completing the build, great price, ease of use saves on your expensive coilovers

Just right

Allowed me to mock up car at ride height without having to worry about my expensive shocks getting banged up during the fabrication stage.

Worked as advertised

Bolted up easy with our Speedway MII suspension kit. Holds everything at ride height without having to guess.

rolling mockup

Using it as a rolling mock up while I do my frame up resto-mod. This way I don't have to continually install and take out the coil springs.

Excellent product!

Great for chassis set up.

Good kit

This kit is largely a combination of other kits. There is a sub-kit for the top "shock mount", which consists of washers, rubber donuts, and a nut for the top shock pin. Speedway incorrectly supplies a nut with a course thread, while the supplied stud that screws into the main shaft has a fine thread (24tpi). I had to go get a couple of correct nuts from the hardware store in order to make it work. The other sub-kit consists of the lower mount with a couple of options for the collar for the horizontal bolt. This lower sub-kit screws into the main shaft and provides some flexibility in adjusting the overall height. In my particular case, even fully extended it was too short. I ended up cutting the main shaft in half and welding the two halves together inside a tube collar, which provided the custom length I needed.