Black Aluminum 3/16 10-32 Throttle Linkage Swedged Tube, 9.5 In.
Universal Fit, 0.31" Shaft Diameter, 3/16" (10-32) RH/LH Thread Pitch, Aluminum, Anodized
This swedged throttle linkage tubing is tapped 3/16" (10-32) LH and RH thread. One end of the throttle rod will have left hand threads, and the other end will have right hand threads. Made of 5/16" x 0.049 round aluminum tubing.
- Aluminum construction
- Anodized finish
- 0.31" shaft diameter
- Sold each
When measuring for your tube length, you will want to allow 1.5" in length for the rod ends (3/4" of length for each end when calculating your eye-to-eye measurement). For instance, an eye-to-eye length of 11.5" would require a 10" swedged tube.
- Get FREE shipping when your order includes this item and exceeds $99! Ground shipping only in the contiguous US.
Q & A
Pat talks about some of our Lokar throttle cable and pedal setups.
Learn how to replace a fuel sending unit. Our fuel gauge sending unit guide and installation video covers all you need to match your fuel sender and gauge.
Do you have carbs sitting on the shelf waiting to be put on? Heath talks about the preparation and parts needed to install a set of Super 9-7 Carbs on his 1949 Flathead 8BA V8 Model A.
Learn about Dual Carb Linkage Setup. Follow along as an expert works through his fuel and throttle setup including part mounting and some modifications.
Fuel injection is here to stay and we delve into the benefits of such retrofit systems for your classic muscle car or street rod in our EFI retrofit buyer's guide!
We look at the basics of performance carburetion and what you need to properly supply your street or race car with enough fuel in this buyer's guide
Follow this detailed guide on installing a FiTech EFI system in a '67 Chevelle. Learn helpful tips along the way including how to route the blue trigger wire away from the coil and ignition system.