Stromburg Type 97/ 9 Super 7 Deluxe Renew Kit

This Stromberg 97 master carb rebuild kit is intended for use on carburetors that need cleaning and require minor replacement of parts, but are otherwise in satisfactory mechanical condition. This Stromberg 97 rebuild kit includes a complete gasket set, needle & seat, air bleed screws, size 48 jets, and accelerator pump.

Works on original Stromberg 97 carburetors.

Modern solid Nitrophyl float for your vintage Stromberg 97-style carburetor.

We offer these stainless steel bolt kits for the famous Stromberg 97 series carbs. Includes most external screws needed to dress up your carb less the mounting stud kit. (Order separately, studs are not stainless steel.)

 

Need to replace your original accelerator pump spring on your 9 Super 7® carburetor? This is the replacement spring that you need. It's important to make sure the spring you are using does not wear out so that your accelerator pump rod functions as it needs to.

• Replacement accelerator pump spring
• For 9 Super 7® Carbs

About the only way your 97 could have a tight throttle shaft would be if you found a NOS carb somewhere. Now you can build yourself a dual or triple carb three deuce set-up that will run like new. We offer you these new extended throttle shafts that are .282", which is .005" oversize. You simply run a 9/32" drill bit or reamer through the base plate and you now have a tight carb again.

• Extended throttle shaft
• .282" which is .005" oversize
• Fits 97-style carbs with throttle bore centers of 1.333"
• Threaded screw hole & machined step to work with OEM throttle linkage
• Stub shaft to clamp a linkage arm onto it for multi-carb linkage
• Butterfly screws included
• Brass construction
• Threaded End to Center of 1st Butterfly Screw Hole:  1-5/16"