Speedway Door Wiring Loom Conduit Kit

Most Liked Positive Review

I bought both power door locks and power windows from Speedway. I had to run 7-14 gauge wires for the left door and 6 for the right which includes a ground wire. I had great difficulty running this many wires (one at a time)..they would go part way and jam up. I discovered that the set screw that holds the wire shield tubing into the bushing had partially crushed the inside diameter plastic lining. (assembly from the mfg). I finally removed the set screw, assembled the loom with wires through the door frames as designed, and then finally replaced the set screw into the bushing to hold it in place. Since the wires do not move inside the tube, I'm trusting the crush on the wires inside the plastic lining will not damage the insulation on the individual wires. I'm thinking it won't. There must be free movement inside the kick panel for the tube end with wires exiting the end, to move forward and backward as the door opens and closes. Some sort of adhesive holding the bushing to the shielded tube would be a better solution at the factory. With fewer wires it may not be a problem.

Most Liked Negative Review

Bought this for the Factory Five 33 Hot Rod suicide doors. Could not bend the required radius for use.