Push Broom Holder, 8 Inch X 5 Inch, Aluminum

• Laser cut and press bent from .125-inch thick aluminum
• Hook is 3.4 inches deep and 8-inches wide to fit most any push broom head
• Mounts via three pre-drilled 1/8-inch holes
• Attaches via tapping screws, bolts, or rivets (user provided)
• Mount to shop wall, trailer wall/cabinet, support beam, etc.

A Home for Your Shop’s Push Broom That Keeps It Out of The Way

Every shop and even a lot of car trailers have a push broom to keep floors and work areas clean. Regular sweeping keeps debris that can damage tires off the floor and creates a safer work environment. Especially if you must go down and dirty and flat back something right there in the shop or trailer. Problem is when the shop’s push broom isn’t in use where does it go? Some lean it up against the wall or possibly stick it in a corner. The issue with this answer is the push broom head is always being tripped on, or worse, you make contact and end up with a broom handle to the face. The better answer is to hang it up out of the way, but within quick reach, with a broom and mop holder.

Using a mop and broom holder wall mount will not only allow safe storage of your push broom but makes it quickly and easily accessible. Simply lower the push broom’s head into the broom rack wall holder and watch the 1/8-inch thick laser cut, and press bent wonder cradle your push broom like a newborn baby. When you need your push broom to clean up it’ll always be right where you left it in the broom and mop holder, ready to go. We provide three predrilled 1/8-inch mounting holes in the mop and broom holder rack, and you provide the fasteners to install it. Rivets for your trailer, tapping screws for your press board shop wall, whatever you choose for the surface you’re mounting the broom rack holder to. Don’t let your push broom languish in a corner, secure it easily with our broom holder wall mount.