Landrum Gold Series Front Coil Springs, 9.5 In x 5 In OD

All front springs are closed and ground on one end to provide proper contact with the jack plate, not forged. The opposite end is either open or closed tangential to fit properly into the lower control arm.
Made of the highest grade of Chrome Silicon wire found worldwide.

Rate:

Select a rate

Starting from

$89.99

/each

In Stock

Quantity

Need Help? Call to Order

Add to a list

Select a vehicle to verify Fitment

Select Vehicle

Product Summary

All front springs are closed and ground on one end to provide proper contact with the jack plate, not forged. The opposite end is either open or closed tangential to fit properly into the lower control arm.
Made of the highest grade of Chrome Silicon wire found worldwide.
Cold wound, not hot wound. Each coil-over spring is properly heat treated and stress relieved to insure the sides of spring remain parallel during installation.
Standardized testing procedures.
Powder-coated, not plated to protect the spring from hydrogen embrittlement, a corrosive break down of the spring's surface which decreases the spring's life.

Need help?

Quick and Easy Returns

All front springs are closed and ground on one end to provide proper contact with the jack plate, not forged. The opposite end is either open or closed tangential to fit properly into the lower control arm.
Made of the highest grade of Chrome Silicon wire found worldwide.
Cold wound, not hot wound. Each coil-over spring is properly heat treated and stress relieved to insure the sides of spring remain parallel during installation.
Standardized testing procedures.
Powder-coated, not plated to protect the spring from hydrogen embrittlement, a corrosive break down of the spring's surface which decreases the spring's life.
Each spring is designed with the correct pitch and height ratio to insure consistent rate throughout the entire cycle.
Every Landrum Coil spring comes with a dyno sheet. The dyno sheet shows the dynamic rate and force output for the spring in 0.200" increments. This allows the customer to know exactly what the spring rate is and means when you change a spring, you know exactly what change is being made.
Custom winding is available upon request.
The material and workmanship in these springs are second to none and proudly Made in the USA.

KEY SPECS
MFG. Part #	Select Rate to see
Brand	Landrum
Position	Front
Spring Rate	Select Rate to see
Free Height	Select Rate to see
Outside Diameter	5"
Inside Diameter	5"
Material Type	Steel
Finish	Matte
Color	Gold
Intended for Street Use	No

GENERAL
Sold in Quantity	Each
Notes	Fits race car suspension setups. Measure spring size needed for proper fitment.
Progressive Rate Spring	No
Bushing Included	No

Be the first to ask a question.