IMCA Low Friction Short Arm 3-Piece Spindle w/Speedway Rotors

Speedway Motors is proud to introduce our exclusive 3-piece "Short Arm" Metric replacement spindle. Our advanced engineering techniques allowed for a redesign of the spindle in a newly forged, heat-treated steel design that is stronger than the original. These spindles serve as a replacement for cars currently running Pinto/Mustang II setups. The 8 degree pin inclination not only improves handling and driver feel, but also dynamically adds cross weight to the car during counter steering which leads to increased drive off the corner. Accepts '79-Up GM Metric rotors, calipers, stock tapered lower ball joints and is reamed to accept 7 degree upper ball joints. These spindles IMCA/USMTS/USRA/UMP/Wissota approved for use in competition. 

Works as replacement for both right or left hand spindles. Steering arm and caliper bracket sold separately.

• Includes spindle body
• Steering arm and caliper brackets
• 10-1/2" Speedway rotors with 5 x 5" bolt circle pattern
• Fits(L) Left or (R) Right side
• Forged, heat-treated steel
• Improves front end geometry
• Approved for use in IMCA/USMTS/USRA/UMP/Wissota sanctioned events
• Upgraded DRP bearings, spacers, seals and grease

IMCA Approved

 

Kit Includes

(2) Speedway Motors Short Arm Metric 3-Piece Spindle, Body Only

(2) Speedway Motors Pinto Repl 3-Piece Short Arm Spindle Steering Arm, Left and Right

(2) Speedway 1979-Up GM Metric Midsize Spindle Caliper Bracket, Left and Right

(1) 1979-Up GM 3-Piece Metric Spindle Bolt Kit

(2) Lightweight Hybrid Rotor for GM Metric, .810 Thick

(2) DRP 007 10521S 1979-Up GM Metric Spindle Pre-Load Bearing Spacers

(2) DRP 007-10581 Premium Finished GM Metric Front Bearing Kit

(2) DRP Performance Products 007 10577 Ultra Low Drag Hub Seal

(1) DRP 007-10756 Ultra Low Drag Bearing Grease Syringe, 50 Grams