ICT Billet 551928-F050 LS Engine Swap Mounting Brackets

• Compatible with the use of 1975-1987 OEM style rubber frame mounts (sbc engine used clamshell style mounts) (1988 and up will not work with these swap adapters)
• These adapters will position your bellhousing 0.5" inches further forward than the OE location of bellhousing
• LS crankshaft centerline is the exact same height as the original SBC engine with these adapters
• Made in Wichita, Kansas from USA produced steel
• Includes: 2 engine mount upper adapter plates and mounting hardware

• Made with OEM specifications for the best possible fitment into your vehicle
• Powdercoated Black finish
• See our other listings for all your LS swap needs. Check out our "Tips and Guides" section on our page

1975-1987 small block chevy clamshells have a recessed triangle on the bottom of the clamshell (recessed away from the engine when bolted on)

1988-2002 small block chevy clamshells have a protruding triangle on the bottom of the clamshell (protruding towards the engine when bolted on)

These LS engine conversion motor mount adapters create clearance interference with the OEM lower passenger side A/C compressor bracket. The factory bracket is not compatible in this configuration. Proper A/C fitment requires either a compressor relocation bracket or an aftermarket accessory drive system utilizing a smaller, short body A/C compressor.