60 INCH 9"REAR END HOUSING

This is Garage Sale priced due to cosmetic imperfections. The item functions as originally intended but is discounted due to the blemishes. The photos above will show the imperfections.

NO WARRANTY, NO RETURNS ON GARAGE SALE ITEMS

Looking for a budget-friendly and rock-solid foundation for your custom rear suspension? Look no further. These fabricated steel Ford 9" rearend housings feature all-new components for maximum durability. This housing is pumpkin-centered, which will offset the pinion yoke about 1". This is done to make fabricating a triangulated 4-link system much easier. Simply weld on your preferred brackets and add the axle shafts and 3rd member of your choice (sold separately), and you have yourself a rolling chassis!

Total wheel-to-wheel mounting surface width is 60" (from hub-to-hub). The pumpkin is centered in the housing, which puts the pinion 1" offset from center, requiring different length axle shafts. For this 60" housing you will need one 30-5/8" long axle and one 28-1/4" long axle. This housing includes (8) T-bolts for the axle bearing retainer plates and (10) studs for the third member.

• New fabricated steel center section
• New 3" O.D. axle tubes w/ 3/16" wall thickness
• New billet steel "New Big Ford" style bearing ends (a.k.a. bearings w/ 2.50" axle shaft flange offset from housing flange)
• Assembled rearend measures 60" from hub-to-hub (a.k.a. axle flange face-to-face)
• Housing measures 55" from housing flange-to-housing flange
• Centered pumpkin w/ 1" offset pinion yoke
• Requires different length axle shafts, left/right
• Includes studs for 3rd member and T-bolts for bearing retainer plates
• 3rd member stud nuts/washers not included/available as # 919-0916
• Includes vent on driver side axle tube
• 3rd member sold separately