Ford 9 Inch 31 Spline Standard Steel Full Spool and Overhaul Kit

Kit Includes:

• (1) Speedway Oval Track Racing 9 Inch Ford 31 Spline Standard Steel Full Spool
• (1) Speedway 9 Inch Ford Rear End Overhaul Kit

Speedway Oval Track Racing 9 Inch Ford 31 Spline Standard Steel Full Spool

All Ford 9" full spools use overhaul kit #919-0950-31, even if they are a 28 spline spool. The 919-0950-31 contains the large I.D. standard O.D. carrier bearings and pinion bearings. Standard steel spool weighs 8.0 lbs.

• Spline Count: 31
• Spool Weight: Standard
• Weight: 8.0 lbs.
• Material Type: Steel

Speedway 9 Inch Ford Rear End Overhaul Kit

This 9" Ford overhaul kit includes: pinion pilot, pinion shaft, pinion nut, pinion seal, gasket, shims, crush collar, sealant, gear marking grease, brush and Loctite. Ring gear bolts not included. All Ford 9" full spools use overhaul kit 9190950-31, even if they are a 28-spline spool. The 9190950-31 contains the large I.D. standard O.D. carrier bearings and pinion bearings needed for use with our full spools.

If you are using the H.D. nodular iron center section which uses the large diameter carrier bearings, order kit 9190950-31s, which also includes the large pinion bearings for use with the Daytona pinion support.

• Includes carrier bearing # LM102949
• 31-spline axles DO NOT guarantee that the LM102949 bearings are used in the carrier. If in doubt, double check the bearings used and then order accordingly.

- Double check your bearing p/n.

9 Ford Carrier Bearing Chart (GIF)