Edelbrock 14063 Performer 600 CFM Electric Carburetor/Stud Kit

Top off your engine with these carburetor installation kits with mounting hardware.

Kit Includes:

• (1) Edelbrock 14063 Performer 600 CFM 4 Barrel Carb, Electric Choke, Black
• (1) Carburetor Stud Kit, 1-3/8 Inch

Edelbrock 14063 Performer 600 CFM 4 Barrel Carb, Electric Choke, Black

• Edelbrock Performer Series carbs have proven themselves to be easy to tune with great drivability
• Whether you need to replace an aging stock four barrel carb or are looking for a performance carb to top off your hot rod, the Edelbrock Performer Series four barrel carbs are the best choice for performance and value
• All Edelbrock products are proudly made in the U.S.A
• CALIBRATED FOR FUEL ECONOMY
• Designed for small-block and small displacement big-block engines, this four barrel carb is recommended only for stock to Performer level applications
• Not recommended for use on RPM or Torker II intake manifolds
• Match with an Edelbrock Performer or Performer EPS manifold and other brands of similar design
• Calibrated 2% leaner than #1405
• Includes both timed and full vacuum ports for ignition advance
• These Performer Series carburetors with black powder coated finish feature gold iridited linkage and hardware that complements the new finish
• When matched with Edelbrock's black powder coated intake manifolds, water pumps and accessories, they give any engine bay a custom appearance
• This new finish will also give these carburetors a durable protective layer that will keep them looking great for many years
• All Edelbrock Performer Series carburetors feature factory set float levels that rarely need adjustment, allowing them to run right-out-of-the-box
• They are constructed of a two-piece design with the gasket above the fuel level for a leak-free operation
• Includes electric choke and detailed instructions
• Ford/Mopar throttle adapter arms sold separately

Features:

• Electric choke 
• Bolt-on-and-run performance right out of the box
• Smooth throttle response throughout the power band
• Lightweight all-aluminum body is compatible with gasohol and blended fuels
• Includes both timed and full vacuum ports for ignition advance
• Uses metering rods to transition between circuits - rods can be changed in seconds without carburetor removal or draining fuel
• Float levels are factory set; adjustments are rarely needed
• Change jets, adjust floats & replace needles/seats without draining fuel or removing carb
• Two-piece design means no gaskets below the fuel level for leak-free operation

Carburetor Stud Kit, 1-3/8 Inch

• Easy installation/removal of carb plates
• Includes zinc plated steel studs, nuts and washers
• 1-3/8" tall

Edelbrock 600 CFM 4 Barrel Carburetor Installation Instructions(PDF)