Edelbrock 1406 Performer 600CFM Carb w/8131 and 8123 Fuel Line

Kit Includes:

• (1) Edelbrock 8131 Performer Carb Fuel Line Kit & Fuel Filter, -6 AN Inlet
• (1) Edelbrock 1406 Performer 600 CFM 4 Barrel Carburetor, Electric Choke
• (1) Edelbrock 8123 Performer Fuel Line & Fitting Kit, Fuel Pump to Filter
• (1) Carburetor Stud Kit, 1-3/8 Inch

Edelbrock 8131 Performer Carb Fuel Line Kit & Fuel Filter, -6 AN Inlet

• The drop-down design routes the fuel line on the right-hand (passenger side) of the carburetor below the linkage and choke housing
• The Edelbrock #8131 includes a polished aluminum fuel filter with a 40-micron filter element and -6 AN male inlet will accept an Edelbrock fuel line kit for a complete fuel pump to carburetor plumbing solution
• The Edelbrock #8131 is manufactured of plated steel and include a 5/8" -20 threaded banjo bolt with gaskets

Edelbrock 1406 Performer 600 CFM 4 Barrel Carburetor, Electric Choke

• Electric choke 
• Bolt-on-and-run performance right out of the box
• Smooth throttle response throughout the power band
• Lightweight all-aluminum body is compatible with gasohol and blended fuels
• Includes both timed and full vacuum ports for ignition advance
• Uses metering rods to transition between circuits - rods can be changed in seconds without carburetor removal or draining fuel
• Float levels are factory set; adjustments are rarely needed
• Change jets, adjust floats & replace needles/seats without draining fuel or removing carb
• Two-piece design means no gaskets below the fuel level for leak-free operation

Edelbrock 8123 Performer Fuel Line & Fitting Kit, Fuel Pump to Filter

• For Performer Series Carburetors
• Pre-fitted Stainless Lines
• Connects From Filter to Pump
• (For S/B Chevy, S/B Chrysler, and B/B Chrysler)

Carburetor Stud Kit, 1-3/8 Inch

• Easy installation/removal of carb plates
• Includes zinc plated steel studs, nuts and washers